7 Ways You're Ruining Your Press: Part 1

Let’s cover several mistakes you might be making with your press, and then let’s fix them fast. We address a few issues this week in Part 1, and we’ll return next week and wrap things up with a few more errors in Part 2.

Mistake #1: Poor Stance
When you unrack the bar, don’t walk a mile back from the rack, and don’t take a narrow stance. Simply take two small steps back - right, then left - that’s it. Two half-steps, if you will - i.e., stay relatively close to the rack. When you do so, set up with a nice, wide stance. Your squat stance will serve as a good approximation of the stance you’re looking for, and you can even stand a bit wider than that, but don’t take a narrow stance.

Mistake #2: Atrocious Grip Width
Don’t take a wide grip. When pressing, the grip is fairly narrow - when taking your grip, simply reach out in front of you like you’re Frankenstein’s monster, and that will serve quite well for your grip width. Don’t use a grip width that looks even remotely as wide as your bench press grip.

For a lot of guys, this will place the grip right on the edge of the knurl, and for a lot of gals, this will place the index finger on the smooth part of the bar and the rest of the fingers on the knurl. These are very general approximations, so to check your grip width, remember that - when you’re setup and ready to press (i.e., at the bottom of the movement) - you want vertical forearms as seen from directly in front of you.

Mistake #3: Terrible Elbows
Don’t let your elbows be situated behind the bar when you’re set up and ready to press. When unracking the bar, do so with your legs. Dip down far enough (with your legs) so that you can move your elbows into the correct position, which is slightly in front of the bar as viewed from the side. Every single rep should start with your elbows in this position. If the elbows are behind the bar, you will tend to press the bar forward, which makes for a miserable pressing experience.

Mistake #4: Hideous Wrists
Your wrists should not be bent back in extreme extension. Go ahead and make a tight fist - yes, right now . . .while you’re reading this . . . seriously. Notice the amount of wrist extension you see, i.e., notice how much - or rather how little - your wrists are bent backward. We’re looking for that position when pressing as well - about 10-15 degrees of wrist extension.

We want the base of the palm to support the bar so that the bar is situated directly over the bones of the forearm. On the other hand, if the wrists are bent back in extreme extension, the bar sits up near the pads at the base of your fingers with your wrists in a very floppy and inefficient position (see the video above).

Your wrists shouldn’t be totally straight (although we may sometimes use the overcue “straight wrists” when setting up), but they definitely shouldn’t be in extreme extension, so get your elbows in the correct position (see Mistake #3), and that permits you to achieve the correct wrist position as well. As the weight gets heavier, you’ll find that a decent pair of correctly worn wrist wraps will certainly help this positioning, but most of the solution is up to you.

We’ll see you next week in Part 2 of this series, and as always, we hope these tips help you get stronger and live better.

(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)

If you found this helpful, you’ll love our weekly email. It’s got useful videos, articles, and training tips just like the one in this article. Sign up below, and of course, if you don’t love it, you can unsubscribe at any time.

---

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Would you like to get quality coaching from a Starting Strength Coach?

How to Start Lifting: Learn to Press

In the fifth video of the "How to Start Lifting" series, Phil and Barb help you learn how to press and also discuss how to go about your first press workout.

(This video is a Blast from the Past video originally published on 11/01/21.)

---

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Click the button below to get quality coaching from a Starting Strength Coach and start getting stronger TODAY.

This Mistake Will RUIN All Your Lifts!

Want to improve every one of your lifts with one fix? Make sure you're doing this.

---

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Click the button below to get quality coaching from a Starting Strength Coach and start getting stronger TODAY.

The Press: Get a Grip!

Add pounds (or kilos) to your press by getting the correct grip and wrist position when you set up!

(This video is a Blast from the Past video originally published on 09/13/21.)

---

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Click the button below to get quality coaching from a Starting Strength Coach and start getting stronger TODAY.

THIS is Destroying Your Press . . . and Driving Me Nuts

This makes me want to throw up in my mouth just a little bit.

Are you adjusting your wrist and elbow positioning after unracking the bar when pressing? Stop that. Stop unracking the press like a doofus. Doofusses (Doofuses? Doofusi?) are the worst at pressing.

We see this mistake often - the mistake of unracking the press, stepping back, and only then getting the elbows slightly forward of the bar and wrists neutral. This is inefficient, it wastes time when you’re supporting the bar, and it gets harder and harder to do as the weight on the bar gets heavier.

In the squat, we don’t make adjustments to the bar or our grip after unracking the bar, and the press is no different.

In fact, this same concept is how you check if you’re doing it correctly - after unracking the bar (i.e., after standing it up from the hooks with your legs), if nothing from your waist upward needs to change position before starting the set, you’ve got it right. You simply take two small steps back from the rack, take a breath, and start the set. On the other hand, if you have to adjust anything above the waist between the unrack and the start of your first rep, you’re unracking it incorrectly.

So, let’s get it right before you unrack it. Set your grip and wrists correctly, dip down far enough (with your hips and legs) so that you can get your elbows slightly in front of the bar, and then stand the bar up while maintaining that exact position. Watch the included video (above) for a quick demonstration of how to correctly - and incorrectly - accomplish this.

If you mess up, don’t fix your wrists and elbows after the unrack; when you do this, you’re reinforcing a bad habit. Instead, simply re-rack the bar, fix it, and then unrack it. Be correct and consistent - from the empty bar up to your work weight, every unracking of the bar should be the same.

If you unrack it correctly every time, your press will be better off, and you won’t look like a doofus. Which is good.

As always, we hope this helps you get stronger and live better.

If you found this helpful, you’ll love our weekly email. It’s got useful videos, articles, and training tips just like the one in this article. Sign up below, and of course, if you don’t love it, you can unsubscribe at any time.

---

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Would you like to get quality coaching from a Starting Strength Coach?

Fix Your Press - Part 7: Correct Your ABOMINABLE Knees

(This is the seventh article in our series on helping you improve your press. Today’s topic - the knees. In this article, you’ll also find a couple of videos related to today’s topic.)

Are you letting your knees unlock when you press? Knock it off - this ain’t a push press. There’s nothing wrong with a push press, but that’s not the lift you’re trying to perform, so let’s fix your soft knees.

When we talk about letting the knees unlock, we are referring to the phenomenon of the knees flexing or bending as you reach with your hips on the press. This is a no-no and is akin to letting your butt come up off of the bench when bench pressing - if it happens, the lift doesn’t count.

Consequently, when you reach forward with the hips to initiate the press, be sure to keep your knees straight - keep them tight, if you will - and with this in mind, here are a few cues to help you with this task:

“Straight knees” or “Straight legs”
This is the simple approach, and if it works, go with it. Merely remind yourself to keep your knees straight as you reach with your hips.

“Flex the quads”
Before initiating the hips movement, tell yourself to flex your quads - those muscles on the front of your thighs that are responsible for straightening your knees (and thus keeping them straight as well). Flex them so hard that you almost get a quad cramp.

“Lift your kneecaps” or “Pull your kneecaps up”
Before starting the press, cue yourself to pull your kneecaps up. If you’re not sure what this looks like, stand up tall and look down at your leg when it’s straight (your knee should be visible, so shorts or rolled up pants are necessary). Now, flex your quad, and as you do, you’ll see that your kneecap actually goes up an inch or so. Check out the video above for a demonstration of this.

“Pull your knees back” or “Keep your knees back”
This is a bit of an overcue as, when you reach forward with your hips, your knees will actually go forward slightly. However, the knees should not ever travel as far forward as the hips, so you can cue yourself to keep your knees back (even as your hips go forward), and this cue often helps solve the problem of bent knees

Keep those knees straight, and as always, we hope this helps you get stronger and live better.

---

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Would you like to get quality coaching from a Starting Strength Coach?