How to Start Lifting: Learn to Press
/In the fifth video of the "How to Start Lifting" series, Phil and Barb help you learn how to press and also discuss how to go about your first press workout.
(This video is a Blast from the Past video originally published on 11/01/21.)
At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Click the button below to get quality coaching from a Starting Strength Coach and start getting stronger TODAY.
How to Start Lifting: Learn to Deadlift
/In the fourth video of the "How to Start Lifting" series, Phil and the Testify gang help you learn how to deadlift and also discuss how to go about your first deadlift workout.
(This video is a Blast from the Past video originally published on 10/25/21.)
At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Click the button below to get quality coaching from a Starting Strength Coach and start getting stronger TODAY.
Tips and Tricks for the New Lifter - Part II
/
Evan demonstrates a handy trick for loading and unloading your deadlift.
(This article is a Blast from the Past article originally posted on 04/16/21.)
In Part I of this series, we discussed several tips and tricks that might help you as a new lifter, and now, in Part II, we’re back with a few more:
Easy Loading for Deadlifts
When you’re loading (or unloading) your deadlift with more than one 45 lb plate per side or more than one bumper plate per side, roll the plate (on the side you’re currently loading) up onto a 2.5 lb plate. This will raise the 45 lb plate or bumper plate off the ground just enough that it makes it easier to slide on the next plate. Of course, using a deadlift jack is makes things even easier, and we have a video on how to make one (click here or scroll down to the end of this article), but in lieu of that, using a 2.5 lb plate works quite well.
Holding Valsalva for Multiple Reps
You can hold your Valsalva (i.e., your tightly held breath) for multiple reps on the bench press. Holding your Valsalva for 2-3 reps is pretty common on the bench press, and as long as you aren’t running out of oxygen, doing so works very well as you don’t have to get tight again before the next rep. Two warnings, though: first, don’t take it as a personal challenge to see how many reps you can get on one breath - this may not end well - and second, holding your Valsalva for multiple reps doesn’t usually work very well for lifts other than the bench press.
Evan shows how to easily remove multiple bumper plates at once.
Easy Unloading for Bumper Plates
If you’re finished snatching, cleaning, or deadlifting (even rowing), and you have multiple bumper plates on each side of the bar, here’s how to unload your bar: first, take the collars off both sides of the bar. Second, unload all of the plates from the left side of the bar. Third, raise the empty left side of the bar - walking it upward (the right side of the bar remains on the ground) until the bar is sitting vertically inside the stack of plates on the right side of the bar. Finally, simply lift the bar out of the stack, put the bar away, and then put the plates away.
We hope these tips help you in your training, and perhaps we’ll be back with a Part III in the future.
(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)