Wrist Wraps: What, Why, When, and How!

If you’re new to lifting, you might have seen these things called wrist wraps, but you might not be sure what purpose they actually serve, so let’s chat.

What are wrist wraps?

Your basic wrist wrap consists of a thumb loop at one end, the elastic body of the wrap, and a hook-and-loop closure system (i.e., Velcro). Countless manufacturers sell wrist wraps with this basic structure - some common ones include Harbinger, SBD, Rogue, Schiek, and the list goes on. A very popular length of wrap is 18”, but you can find plenty of wraps that are both shorter or longer than this (longer is fine, but for most lifters, I wouldn’t recommend anything shorter than 18”). Some manufacturers (e.g., SBD) also make variations of their wraps that are either more rigid or more flexible depending on the lifter’s preference.

Why might I use wrist wraps?

You use wrists wraps when your wrists are in compression, i.e., when you’re pushing on something - not when you’re pulling on something. A wrap gives support to your wrist by acting as an external skeleton for your wrist - you can think of it as a cast or a lifting belt for your wrist. Since the wrap is wrapped around your wrist, it lends support to your wrist and makes it very difficult for the wrist to be in positions of extreme extension (i.e., positions where you wrist is bent very far backward). Lifts that benefit from wrists wraps include all the pressing movements (press, bench press, close grip bench, etc.), snatches, jerks, cleans (this is a gray area as you need your wrists to be in extension to rack a clean), and the squat for those who wrap their thumbs around the bar and have their wrists in extension. Even if you don’t normally use a wrist wrap, it’s probably a good idea to use one if you are dealing with and training through a wrist injury.

When might I use wrist wraps?

A reasonable approach is to treat your wrist wraps the same way you treat your belt - put the wraps on for your last warm-up set, and then use them for all of your work sets as well. With some experience under your belt (under your wraps?), you may decide to put them on earlier than your last warm-up, and that’s fine as well.

How do I use wrist wraps?

1. Place your thumb through the thumb loop so that the wrap drapes over the back of your wrist (see the photo sequence at the end of this article).

2. Position the body of the wrap so that it lies half on your forearm and half on your hand.

3. Apply tension and wrap the length of the wrap around your wrist until you reach the end of the wrap.

4. Close off the wrap by attaching it to itself using the Velcro strap.

5. Remove the thumb loop from your thumb (it is simply there to keep the wrap from spinning in place while you apply the wrap, so you no longer need it).

A wrist wrap worn too low on the arm . . . don’t do this.

Remember: this is not a forearm wrap or a hand wrap - it’s a wrist wrap, so be sure to pay attention to Step 2. If you position the wrap too low, it’s simply a forearm warmer, and if it’s too high, it’s just a weird glove. In effect, the wrap should almost lock those two sections of your arm together (i.e., the forearm and the hand), and to do so, it has to straddle both sections of your arm. If you put the wrap on correctly, it will make it harder to extend your wrist (i.e., bend it backwards), which means the wrap is doing its job of support.

Quick re-wrap solution - pinch the thumb loop between your thumb and index finger and use that setup to anchor the beginning of the wrap in place while you re-tighten the wrap.

The wrap should be very snug - not so tight that you start losing circulation in your hand, but pretty darn tight. It needs to be tight so it can provide support. You will always loosen or perhaps even remove the wraps between sets. If you only loosen the wrap between sets, you don’t need to re-insert your thumb in the thumb loop - a quicker solution is to simply pinch the thumb loop between your thumb and index finger and use that setup to anchor the beginning of the wrap in place while you re-tighten the wrap.

That pretty much wraps it up!

Step 1: Place your thumb through the thumb loop so that the wrap drapes over the back of your wrist.

Step 2: Position the body of the wrap so that it lies half on your forearm and half on your hand.

Step 3: Apply tension and wrap the length of the wrap around your wrist until you reach the end of the wrap.

Step 4: Close off the wrap by attaching it to itself using the Velcro strap.

Step 5: Remove the thumb loop from your thumb (it is simply there to keep the wrap from spinning in place while you apply the wrap, so you no longer need it).

Lifters' Corner: I Forgot My Belt!

Do you ever forget to put your belt on for your heavier sets? Perhaps you forget to wear your wrist wraps every once in a while?

problem solved

These types of situations tend to occur more often when you’re a newer lifter, but even an experienced lifter can forget a belt or wrist wraps every now and then.

If you find yourself in one of the above situations from time to time, try this: hang your belt and wrist wraps on your barbell between sets.

By doing so, you’ll be forced to grab them before starting your next set, and the problem is solved. The next time you lift, give it a try. Hope this helps!

(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)

If you found this helpful, you’ll love our weekly email. It’s got useful videos, articles, and training tips just like the one in this article. Sign up below, and of course, if you don’t love it, you can unsubscribe at any time.

---

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Would you like to get quality coaching from a Starting Strength Coach?

Lifters' Corner: Enter the TUBOW

(reposted from our June 2018 newsletter)

What on earth is a TUBOW?
So glad you asked! A TUBOW is a Terribly Useful Block Of Wood. Many of you have seen us use 2-foot lengths of 4 x 4 lumber when people squat from time to time - these are TUBOWs.

Why would one use a TUBOW?
We use TUBOWs in the squat, and there are a couple reasons we might use a TUBOW. The most common use is to fix the knee's forward position on the way down.

becky’s knees are so far forward that parker refuses to watch.

Two common errors that we see when people squat is either (a) the lifter's knees travel forward all the way down, or (b) the knees travel forward at the bottom of the squat.

We would like to see the knee establish its final forward position about 1/3 to 1/2 of the way into the descent of the squat, and touching the TUBOW with the knee at this point provides excellent tactile feedback as to whether or not the lifter is doing that correctly. If the lifter accidentally knocks the TUBOW over, it provides excellent negative feedback that the knee has traveled too far forward.

becky touches her knees lightly to the tubow during the descent.

Another use of the TUBOW is to fix the knee's lateral position in the squat, i.e., is the lifter shoving the knees out (to the side) far enough, or perhaps even too far? The TUBOW gives the lifter something concrete (well, lumber, actually) to aim for, and very often, this will help solve the issue.

One of the great side effects of fixing the knee position is that it will often fix the back angle in the squat as well. If the lifter's knees can only travel "so far" forward on the descent, then the hips will have to travel backward (since your hips and knees are connected by your femurs . . . you know . . . the leg bone). If the hips have to travel backward, the lifter will have to lean over during the descent to avoid falling over backward and stay balanced on the midfoot, and that leaned over position is precisely what we want in the low bar squat. Pretty awesome.

Are you one of those people who is deeply, intensely, spiritually, emotionally, and morally opposed to using the TUBOWs? If so, you're probably the type of person whose squat would benefit most from using them. And if your squat benefits, then you benefit, because you'll get stronger - faster.

Where do I get a TUBOW?
You can go to your nearest lumber supply store and get a 4 x 4 (and they'll often cut it to size for you), but if you'd rather just order a 2 foot section of 4 x 4 online and have it show up at your front door, then just click here.

(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)

If you found this helpful, you’ll love our weekly email. It’s got useful videos, articles, and training tips just like the one in this article. Sign up below, and of course, if you don’t love it, you can unsubscribe at any time.

---

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Would you like to get quality coaching from a Starting Strength Coach?