Mistakes New Lifters Make - Part II

Parker and Milo make all kinds of mistakes - mistakes only redeemable because the two furballs are moderately cute.

Parker and Milo make all kinds of mistakes - mistakes only redeemable because the two furballs are moderately cute.

(This article is a Blast from the Past article originally posted on 03/26/21.)

In Part I of this series - Common Mistakes New Lifters Make (and how to avoid them!) - we discussed the common errors of misloading your bar, forgetting to wear your belt, and forgetting to use chalk or a hook/switch grip for your deadlift. In Part II, we’re going to examine a few other mistakes that new lifters are likely to make, and hopefully, we can help you avoid them or at least quickly correct them. Most of this list is inspired by conversations we have at the gym with new (and sometimes experienced!) lifters, and the mistakes are not listed in any particular order.

Setting the j-hooks too high for the squat (or press/bench press)
For some reason, new lifters often set their j-hooks too high for their squat. You should never be at risk of catching the edge of a hook with the barbell when either unracking the bar at the beginning of your set or racking the bar at the end of your set, so err on the conservative side and set the hooks a bit lower than you think you should. Mid-sternum is a good height to start with, and remember, too low is better than too high - nobody should have to do a calf raise to rack the bar - and you can always raise the hooks later if you’ve set them too low.

Looking for the j-hooks when racking the squat (or press/bench press)
It can be tempting to look at the j-hooks as you’re racking the bar after your last rep. Don’t. Unless you have an exceptionally sneaky and cruel training partner, the hooks didn’t go anywhere while you were squatting, so stop treating them like they have legs. When you’re finished with your last rep, look straight ahead and walk forward until the bar makes (and keeps) solid contact with both uprights. At this point, you’ll know the bar is over the hooks (assuming you set the hooks at a reasonable height - see the previous paragraph), and you can then safely lower the bar down to the hooks. Looking at one hook makes it very likely that you will miss the other, and this tends to be a rather disastrous event - it might not happen today, but it will happen. Don’t look at the hooks.

Breathing in or out while the bar is moving
New lifters often breathe out when the bar is moving upward - we have years of fitness magazines to thank for this inane idea. Again, don’t. Remember: if the bar is moving, you’re not breathing. Instead, inhale before the rep starts and exhale after the rep ends. In other words, all breathing takes place between reps - not during - and for crying in the beer cheese soup, don’t blow your air out at the top of your deadlift. Wait the quarter of a second it takes to lower it to the ground and release your breath when the bar is back on the floor. Watch the video below for more on how to correctly breathe and perform the Valsalva maneuver.

We hope these tips help you in your training, and we anticipate a “Part III” in the near future.

If you found this helpful, you’ll love our weekly email. It’s got useful videos, articles, and training tips just like the one in this article. Sign up below, and of course, if you don’t love it, you can unsubscribe at any time.


At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Click the button below to get quality coaching from a Starting Strength Coach and start getting stronger TODAY.