7 Ways You're Ruining Your Press: Part 1
/
Let’s cover several mistakes you might be making with your press, and then let’s fix them fast. We address a few issues this week in Part 1, and we’ll return next week and wrap things up with a few more errors in Part 2.
Mistake #1: Poor Stance
When you unrack the bar, don’t walk a mile back from the rack, and don’t take a narrow stance. Simply take two small steps back - right, then left - that’s it. Two half-steps, if you will - i.e., stay relatively close to the rack. When you do so, set up with a nice, wide stance. Your squat stance will serve as a good approximation of the stance you’re looking for, and you can even stand a bit wider than that, but don’t take a narrow stance.
Mistake #2: Atrocious Grip Width
Don’t take a wide grip. When pressing, the grip is fairly narrow - when taking your grip, simply reach out in front of you like you’re Frankenstein’s monster, and that will serve quite well for your grip width. Don’t use a grip width that looks even remotely as wide as your bench press grip.
For a lot of guys, this will place the grip right on the edge of the knurl, and for a lot of gals, this will place the index finger on the smooth part of the bar and the rest of the fingers on the knurl. These are very general approximations, so to check your grip width, remember that - when you’re setup and ready to press (i.e., at the bottom of the movement) - you want vertical forearms as seen from directly in front of you.
Mistake #3: Terrible Elbows
Don’t let your elbows be situated behind the bar when you’re set up and ready to press. When unracking the bar, do so with your legs. Dip down far enough (with your legs) so that you can move your elbows into the correct position, which is slightly in front of the bar as viewed from the side. Every single rep should start with your elbows in this position. If the elbows are behind the bar, you will tend to press the bar forward, which makes for a miserable pressing experience.
Mistake #4: Hideous Wrists
Your wrists should not be bent back in extreme extension. Go ahead and make a tight fist - yes, right now . . .while you’re reading this . . . seriously. Notice the amount of wrist extension you see, i.e., notice how much - or rather how little - your wrists are bent backward. We’re looking for that position when pressing as well - about 10-15 degrees of wrist extension.
We want the base of the palm to support the bar so that the bar is situated directly over the bones of the forearm. On the other hand, if the wrists are bent back in extreme extension, the bar sits up near the pads at the base of your fingers with your wrists in a very floppy and inefficient position (see the video above).
Your wrists shouldn’t be totally straight (although we may sometimes use the overcue “straight wrists” when setting up), but they definitely shouldn’t be in extreme extension, so get your elbows in the correct position (see Mistake #3), and that permits you to achieve the correct wrist position as well. As the weight gets heavier, you’ll find that a decent pair of correctly worn wrist wraps will certainly help this positioning, but most of the solution is up to you.
We’ll see you next week in Part 2 of this series, and as always, we hope these tips help you get stronger and live better.
(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)
