These Aren't the Rests You're Looking For - Part Deux

/ Testify Strength & Conditioning/

A while back in These Aren't the Rests You're Looking For - Part 1, we covered the importance of being economical with your time between reps in the deadlift. It’s important not to spend any more time than necessary with the barbell sitting on the floor because that semi-crouched position is not a very good resting position.

The same advice applies to the top of the squat as well. When the weight gets heavy, it’s easy to fall into the habit of taking too much time between reps in the squat. You’ve seen this in the gym - the lifter who takes 10-20 seconds between reps 4 and 5 of their work set.

Don’t be this lifter.

Yes, the top of the squat is the easiest place to support the weight, and thus, we take our breath at this position, but don’t spend any more time than necessary here. You’re still supporting a heavy load, and you want to get done with squatting, not simply put off the next rep. Taking 8 breaths and waiting 20 seconds before you squat the next rep simply makes the next rep harder.

Keep it simple. Keep it short. Take 1 breath between each rep, get tight (remember the Valsalva maneuver?), and then squat. You might take 2 breaths (maybe even 3) before your last rep, but don’t use breathing as a stalling technique. That chair over in the corner is a much better resting position than standing at the top of the squat with a bunch of weight on your back. Get the set done - you’ll be glad you did.

We hope this helps you get stronger and live better!

(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)

If you found this helpful, you’ll love our weekly email. It’s got useful videos, articles, and training tips just like the one in this article. Sign up below, and of course, if you don’t love it, you can unsubscribe at any time.

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Would you like to get quality coaching from a Starting Strength Coach?

click here to start today

Week 2022.01.31

/

This Week’s Conditioning

Option 1
Sled Pyramid – 4, 5, or 6 tiers
Go up and down a 4, 5, or 6 tier “sled pyramid” – rest as needed. The distance for each round is 80 m indoors (a down-back on the 40m course) or 200 ft outdoors (2 down-backs on the 50 ft course). Rest as needed.

For example, Bob does the following (4 tiers):
Round 1: Empty sled
Round 2: 25#
Round 3: 50#
Round 4: 75#
Round 5: 50#
Round 6: 25#
Round 7: Empty sled

Compare to 2021.11.29.

Option 2
Bike/row:
4 x 3 minutes

Rest 3 minutes between each round. Score = lowest distance.

Compare to 2021.11.08.

Option 3
Outdoors:
5-10 rounds:
50 yd sled push (25 yd down-back)
50 yd farmer carry (25 yd down-back)
Rest 1 min

Indoors:
5-10 rounds:
100 yd sled push (50 ft down-back)
100 yd farmer carry (50 ft down-back)
Rest 1 min

Compare to 2021.10.11.

Option 4
Row 10 x 100m
Rest 1 min between sprints. Your score is your slowest time.

Compare to 2021.10.11.

Looking Down in the Squat

/ Testify Strength & Conditioning/

A Blast from the Past article originally posted on 11/20/18)

When we teach the squat, we teach people to look at a point on the floor about 3-6 feet in front of them. In other words, we look down (and forward, but I digress). But why?

Loren looks down . . . to go up.

Let's chat . . .

If you lifted in high school, you probably heard some “coach” tell you to look up when squatting. “You gotta look up to go up!” is the loud refrain heard throughout high school weight rooms and powerlifting meets ‘round the world. Rarely is any type of rationale given for this advice, but if pressed for a reason, people might offer something like “ . . . your body follows your head, so to stand up, you should look up.”

This might sound reasonable at first, but let’s think about it. Do you look at the ceiling when you get up out of bed in the morning? What about when you get up out of a chair? I’m going to guess your answer is no. Considering this, we can see that the body doesn’t necessarily follow the head, but it is true that your chest typically does.

Therein lies the major problem with lifting the head while squatting - lifting the head typically causes the lifter to lift the chest. When the chest comes up (i.e., the torso becomes more vertical), the knees shift forward. When the knees shift forward, so do the hips (since the hips and knees are connected by the femurs), and in this “knees forward/hips forward” position, we have now asked the knees to do more and the hips to do less, which is rather silly of us since the hips are the larger of the two joints and are surrounded by more muscle mass than the knees. Without diving too deeply into the physics and anatomy of the situation, we use both the hips and the knees when squatting, and since we want to use them to drive the barbell upward in the most efficient manner possible, that means asking the larger joint (i.e., the hips) to do its fair share of the work.

With this in mind, you look down when you squat since it’s an effective way to keep your hips (and knees) right where they are supposed to be, and this allows you drive upward efficiently with your hips.

As always, we hope this helps you get stronger and live better.

(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)

If you found this helpful, you’ll love our weekly email. It’s got useful videos, articles, and training tips just like the one in this article. Sign up below, and of course, if you don’t love it, you can unsubscribe at any time.

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Would you like to get quality coaching from a Starting Strength Coach?

click here to start today

Week 2022.01.24

/

This Week’s Conditioning

Option 1
”Prowler Base+1”
1. Load up a manageable weight.
2. Sprint 40m at 85% intensity.
3. Rest 30 sec.
4. Repeat 5-15 times.

Courtesy of “Death by Prowler” (on Starting Strength).

Compare to 2021.11.22.

Option 2
Bike/row:
4 x 800m

Rest 3 minutes between each round. Score = slowest time.

Compare to 2021.11.01.

Option 3
1st: 5 x 50 ft seated sled pull. Add weight each round. Rest as needed.
2nd: 5 x 100 ft duck walk. Add weight each round. Rest as needed.

Compare to 2021.10.04.

Option 4
Outdoors
4 rounds:
50 yd farmer carry
80 m sled drag
Rest 2 min

Indoors
4 rounds:
100 ft farmer carry
100 ft sled drag
Rest 2 min

Compare to 2021.10.04.

The LPP Rule: Fewer Barbell Loading Mistakes

/ Testify Strength & Conditioning/

The name in the following story has been changed to protect the guilty . . .

This is not 140 lb . . . and Sally knows better.

One of our lifters - Sally - needed to squat 140 lb for her work sets. However, Sally didn’t want to spend the effort necessary to put a 45 lb plate on each side of the barbell. Bear in mind that Sally squats over 200 lb and deadlifts nearly 300 lb, so it wasn’t as though lifting a 45 lb plate was very difficult for Sally - she just didn’t want to do it.

Consequently, Sally had to use far more plates to load her bar than she normally would have used had she chosen to use a 45 lb plate, and as a result, she made a barbell math mistake and ended up squatting 130 lb for a couple of sets instead of 140 lb. When I noticed this, I pointed it out to her and also pointed out that she now needed to load the correct weight and perform her work sets.

What’s the moral of this story? All lifters make math errors when loading the barbell every now and then, but you can greatly reduce your chances of loading (and lifting!) the wrong weight if you follow one simple rule:

The LPP Rule: Always put the Largest Possible Plate on the bar.

(I recommend watching the included video for a demonstration as well as explanation) 

For example, if you want to squat 140 lb (using a 45 lb bar), simply put a 45 lb plate on each side followed by a 2.5 lb plate on each side. Do NOT use some silly combination of plates such as a 25, two 10s, and a 2.5 on each side, or worse yet, a 25, a ten, two 5s, and a 2.5. The list of terrible combinations goes on and on, and this is exactly the problem.

If you always put the largest possible plate on the bar (the LPP Rule), then there is only one possible combination of plates that will produce the correct weight on the bar. If you don’t utilize this method, there are myriad combinations that will get you the correct weight, and with this greater number of possibilities comes a correspondingly greater number of ways that you can screw up the math and misload your bar.

With the LPP Rule, not only are there far fewer ways to make a mistake, but you’ll also benefit from always building your bar math around “milestone weights” such as 95 lb (one 25 on each side), 135 lb (one 45 on each side), 185 lb (one 45 and one 25 on each side), etc. These milestone weights are numbers that you’ll memorize rather quickly (whether you intend to or not) if you use the LPP Rule, and it makes the bar math for any weight above these weights simpler, quicker, and harder to mess up.

We hope this helps you get stronger and live better!

(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)

If you found this helpful, you’ll love our weekly email. It’s got useful videos, articles, and training tips just like the one in this article. Sign up below, and of course, if you don’t love it, you can unsubscribe at any time.

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Would you like to get quality coaching from a Starting Strength Coach?

click here to start today

Week 2022.01.17

/

This Week’s Conditioning

Option 1
“Prowler Base”
1. Load up a manageable weight.
2. Sprint 40m at 85% intensity.
3. Rest until breathing and heart rate slow down. (45 sec – 2 min)
4. Repeat 5-15 times.

Courtesy of “Death by Prowler” (on Starting Strength).

Compare to 2021.11.15.

Option 2
Bike/row:
4 x 3 minutes

Rest 3 minutes between each round. Score = lowest distance.

Compare to 2021.10.25.

Option 3
1. Work up to a heavy single on the axle clean-and-press (i.e., ground to overhead).
2. 5 x 100 ft Zercher carry (50 ft down-back). Add weight each round. Rest as needed.

Compare to 2021.09.27.

Option 4
Outdoors:
5 rounds:
15 cal row
50 yd sled push, 100#/50#

Indoors:
5 rounds:
15 cal row
100 ft sled push, 250#/125#

Push sled slow for recovery. Score is slowest row.

Compare to 2021.09.27.