Week 2021.03.15

/

The annual Testify Leprechaun Lift-off was a great success this weekend, and we are hugely thankful to everyone who helped out! Loaders, referees, table officials, those who helped setup and tear down - we could not have hosted this meet without you all!

This Week’s Conditioning

Option 1
”Prowler Base+1”
1. Load up a manageable weight.
2. Sprint 40m at 85% intensity.
3. Rest 30 sec.
4. Repeat 5-15 times.

Courtesy of “Death by Prowler” (on Starting Strength).

Compare to 2021.01.11.

Option 2
Bike/row:
4 x 3 minutes

Rest 3 minutes between each round. Score = lowest distance.

Compare to 2020.12.21.

Option 3
Outdoors:
5-10 rounds:
10 sledgehammer strikes (5R, 5L)
50 yd farmer carry (25 yd down-back)
Rest 1 minute

Indoors:
5-10 rounds:
10 sledgehammer strikes (5R, 5L)
100 ft farmer carry (50 ft down-back)
Rest 1 minute

Compare to 2020.11.23.

Option 4
10 x 50 ft farmer carry
Each carry is 25 ft down and 25 ft back and is for time. Rest 1 minute between carries.

Women: 97# per handle (80# of plates)
Men: 137# per handle (120# of plates)
(Note: Each handle weighs 17#.)

Compare to 2020.11.16.

Common Mistakes New Lifters Make (and How to Avoid Them!)

/

If you’re a new lifter, there are a couple of mistakes that you’re probably going to make within your first few weeks or months of training. To help you avoid them, let’s take a look at a few:

Misloading the bar
Bar math can be tough, and you’re eventually going to load your barbell heavier or lighter than you intended. For example, you intend to add 10 lb to the bar, and instead, you absentmindedly add 10 lb to each side of the bar and thus end up adding 20 lb to the bar by mistake.

If you do a work set, and it’s significantly harder than you expected, double-check what’s on the bar. Be sure to check your math if the set is significantly easier than expected as well, and check it again if the weight felt lopsided. In all of these scenarios, there’s a reasonable chance you misloaded the bar. Don’t worry - we’ve all done it, and it won’t be the last time you do it.

Forgetting to wear your belt
You finish your set - it was a bit harder than expected - and you then see your lifting belt sitting on the ground. There’s a very easy solution here - every time you finish a set, hang your belt over the middle of your barbell. Now, you won’t be able to miss it. This also works well for wrist wraps.

Forgetting to use chalk or a hook/switch grip for your deadlift
Grip plays a pivotal role in the deadlift, and you can’t pull as heavy without chalk and a hook or switch grip (or straps) as you can with these things. Eventually, chalking before pulling will be second nature - as will taking the proper grip - but in the meantime, write yourself a large, neat reminder in your training journal. “CHALK + HOOK GRIP” or something of the sort will do nicely.

We’ll examine a few other newbie mistakes in a future article, but in the meantime, give these solutions a try.

Milo understands . . . he’s made a few mistakes, too.

Milo understands . . . he’s made a few mistakes, too.

As always, we hope this helps you get stronger and live better.

-Phil

PS: Whenever you want even more Testify in your life, here are some free resources:

  • Book a free intro and strategy session with us HERE.

  • Pick up a free copy of Testify’s Squat Guide: 12 Tips to Improve Your Squat Now HERE.

  • Get our free weekly email - containing useful videos, articles, and training tips - HERE.

  • Follow Testify on Instagram HERE.

  • Subscribe to Testify’s YouTube channel HERE.

(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Interested in getting stronger, looking better, and having more energy?

book a free intro

Week 2021.03.08

/

Reminder: Please note that the gym will be closed this Saturday, 03/13/21, as we are hosting the annual Testify Leprechaun Lift-off weightlifting meet.

This Week’s Conditioning

Option 1
“Prowler Base”
1. Load up a manageable weight.
2. Sprint 40m at 85% intensity.
3. Rest until breathing and heart rate slow down. (45 sec – 2 min)
4. Repeat 5-15 times.

Courtesy of “Death by Prowler” (on Starting Strength).

Compare to 2021.01.04.

Option 2
Bike/row:
5 min on
4 min off
4 min on
3 min off
3 min on
2 min off
2 min on
1 min off
1 min on

Record distance for each interval and add for total distance.

Compare to 2020.12.14.

Option 3
5-10 rounds of:
30 sec ME tire flips
30 sec rest

Compare to 2020.11.16.

Option 4
10 x 50 ft yoke carry
Each carry is 25 feet down and 25 feet back and is for time. Rest 1 minute between carries.

Compare to 2020.11.09.

Save Time During Your Workouts!

/

You like being at the gym, but you also like other things besides being at the gym, and people are often on a tight schedule, so if your workouts are taking longer than you would like (or can afford), we are going to give you two tactics to save time at the gym. These tactics both revolve around the warm-up, because the warm-up is the best place to save time when you train.

First, don’t rest between your warm-up sets. You need to change the weights as you warm-up, and the act of unloading and loading plates between warm-up sets will provide enough rest for the purpose of warming up. Remember, these are warm-up sets - they’re not terribly difficult - you don’t need a whole lot of rest. After your last warm-up set, you’ll want to rest a few minutes (perhaps 2-4 minutes) before performing your first work set, but if you’re resting 3-5 minutes between all of your warm-up sets and you’re wondering how to shorten your workout time, this is where you start.

Second, if you really need to speed things up, start warming up your next lift between the work sets of your current lift. Let’s say you’ve just done your first work set of squats, and bench press is your next lift - while you’re resting, go ahead and grab a barbell and do your empty bar warm-up for the bench (if it’s the press, you don’t even need a rack - you can just pick it up off the floor and press it). Then, sit down and rest until it’s time to squat again. After your second set of squats, go ahead and do your next bench warm-up set. You might still have some warming up to do on the bench press when you’re done squatting, but this method will certainly shave some time off the length of your training session.

Most importantly, don’t let this tactic tire you out for your current work sets. The squat/bench press example we’ve given here will not tire you out for squatting because the bench press warm-ups are light and because the bench press is unrelated to squatting, but warming up your deadlift between work sets of squats may not be the greatest idea.

Try these tactics the next time you train, and you’ll save yourself some valuable time. Of course, you could probably shorten those 15-minute-between-set-conversations you have with your lifting buddies as well.

As always, we hope this helps you get stronger and live better.

-Phil

PS: Whenever you want even more Testify in your life, here are some free resources:

  • Book a free intro and strategy session with us HERE.

  • Pick up a free copy of Testify’s Squat Guide: 12 Tips to Improve Your Squat Now HERE.

  • Get our free weekly email - containing useful videos, articles, and training tips - HERE.

  • Follow Testify on Instagram HERE.

  • Subscribe to Testify’s YouTube channel HERE.

(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Interested in getting stronger, looking better, and having more energy?

book a free intro

Week 2021.03.01

/

This Week’s Conditioning

Option 1
Sled
Outdoors:
10-20 x 25 yds EMOM at a weight of your choice

Every minute, push the sled 25 yards, i.e., if pushing the sled takes 20 seconds, then you have 40 seconds to rest. Perform 10-20 rounds.

Indoors:
10-20 x 100 ft EMOM at a weight of your choice

Every minute, push the sled 100 feet, i.e., if pushing the sled takes 20 seconds, then you have 40 seconds to rest. Perform 10-20 rounds.

Compare to 2020.12.28.

Option 2
Bike/row:
4 x 3 minutes

Rest 3 minutes between each round. Score = lowest distance.

Compare to 2020.12.07.

Option 3
Outdoors:
5-10 rounds:
50 yd sled push (25 yd down-back)
50 yd farmer carry (25 yd down-back)
Rest 1 min

Indoors:
5-10 rounds:
100 yd sled push (50 ft down-back)
100 yd farmer carry (50 ft down-back)
Rest 1 min

Compare to 2020.11.09.

Option 4
For time:
500m row
5 x 80m sled push (200 ft if indoors)
500m row

Rest 1 minute after the first row and after each sled push.

Compare to 2020.11.02.

Simple and Cheap DIY Chalk Stand

/ Testify Strength & Conditioning/

When you chalk up for your next set, it’s nice to have a chalk stand. It’s not absolutely necessary, of course, as you can just use a bag of chalk or - better yet - a chalk bucket sitting on the ground. Although those options work, a chalk stand makes much less of a mess than a bag of chalk, and as the stand is raised, you don’t have to reach all the way down to the floor level as you do with a bucket of chalk, which can be a bit of pain if you already have your belt tightened.

With all this in mind, here’s how you can make a simple and cheap chalk stand (feel free to watch the video above if you’d rather not read the steps below):

Step 1
Go to your nearest hardware store and purchase the following items (you may already have some of these items at home). If you’d rather not make the trip, you can click the items below and order from Amazon.

Step 2
Set one bucket on the ground - upside down.

Step 3
Set the other bucket on top of the first bucket - right side up. The closed ends of the two buckets should now be touching.

Step 4
Tape the two buckets together by wrapping duct tape around the buckets several times. Tape the “seam” between the buckets as well as above and below the seam. Five or six times around the buckets should do nicely.

Step 5
Spray paint the buckets. This step is optional and is for aesthetic purposes only - it covers up any logos or printing on the buckets. It’s nice to have the paint match the buckets (or as closely as possible) for two reasons:

  • This is supposed to be a quick process, so don’t worry too much about whether you’ve painted the entire apparatus or not. If the logos are covered and the paint closely matches the bucket, it will look just fine.

  • Eventually, the paint will chip or wear in places, and if the bucket is close to the same color as the paint, this won’t be a big deal.

Step 6
Place the lid on the ground - upside down - with a brick, 10 lb plate, or some other relatively heavy object on top of the lid, and then set your new chalk stand on top of the lid and press down so that the lid is attached to the stand. You’ve now weighted the base of your chalk stand and made it much less likely to tip over and spill.

IMG_6318.JPG

Step 7
Put a chalk-topper over the top of the stand. This is optional, but if other people use your chalk stand, you’ll find this greatly helps keep the chalk dust inside the stand. Our chalk toppers are from www.junkbrands.com.

IMG_6316.JPG

Step 8
Place some chalk in the top bucket, and you’re good to go!

As always, we hope this helps you get stronger and live better.

-Phil

PS: Whenever you want even more Testify in your life, here are some free resources:

  • Book a free intro and strategy session with us HERE.

  • Pick up a free copy of Testify’s Squat Guide: 12 Tips to Improve Your Squat Now HERE.

  • Get our free weekly email - containing useful videos, articles, and training tips - HERE.

  • Follow Testify on Instagram HERE.

  • Subscribe to Testify’s YouTube channel HERE.

(Some links may be affiliate links. As an Amazon Associate, Testify earns from qualifying purchases.)

At Testify, we offer small group training, private coaching (in-person or remotely via Zoom), online coaching, and form checks. Interested in getting stronger, looking better, and having more energy?

book a free intro